A short press of the a home control button will power on your device(s), performing a long press will power off them off. Each button will either have an individual or group of lights or smart plugs assigned. Home Control Buttons: Controls your smart home devices.Individual AV devices should not be accessed in device mode for daily use. Devices Screen: Primarily designed to access home control devices such as lights, thermostats, and locks.Harmony will remember what is powered on and only change what's needed. Tip: You do not need to press Off when switching between two Activities.*Some devices may be set by the remote to remain on all the time. For example, powering off your Watch TV Activity will power off the TV, cable box and soundbar. Off Button: Turns off all the devices included in the Activity.Once set up, starting your Watch TV Activity and your volume will automatically control the stereo, and channels will automatically change your TV. Activities: Harmony controls Activities such as Watching TV or Playing a Game.Then click Skip IP Scan again and you are done. However, you will be able to control your Roku Ultra using IR commands. If you skip scanning for Roku Ultra on your Wi-Fi network, you will not be able to: When it searches for it, immediately say Skip IP Scan Manufacturer Roku, Model Ultra (or whatever) So…in Insteon app, remove Roku as a device. Or have an IR Blaster pointing at the Roku is behind a door or inside a cabinet. Your Roku probably needs to be next to the Harmony Hub like mine is. The trick is to not use Wi-Fi to control the Roku, but instead use IR or infrared. I had the same problem: when using Harmony Hub and Remote with Roku, button presses would sometimes work or lag by 1 second, or even 5-10 seconds making it unusable. If that link is gone, the control is IR, everything technically works, but there is a network timeout between each remote press. If its not working, it waits for a timeout (hence router timing parameters improving things) then tries an IR command. So each press tries an IP connect and waits for success. The problem seems (this is an educated guess with reasonable data) to be that the hub to roku IP connection, if found during config, whether it works or not, is the default hub mode for Roku connect. The fix is to get the Hub thinking it needs IR and doesn’t have an IP option. If you din’t have IP, the Hub doesn’t adapt. Put the Hub in IR mode with the requsite whinging, and after fixing things, the delay was gone. Seems the Hub still thinks IP is OK.įixing required deleting the Roku (or adding a Roku 2) and skipping past IP scan. Played with an IR input and a network sniffer. Returning the connection to wired created the awful remote control delay. I wanted to play with a macro to access roku channels so I switched the Roku to a wireless connection, To get IP to the Roku, I created another Roku 3 and configured it. The Hub defaulted to IR and everything worked, with expected limitations. When initially set up, the IP scan for the Roku didn’t find it. My Roku is using a direct hardwired connection. I’ve managed to fix it, at least for my installation, and I think I know the cause. Just got a hub and have encountered the same problem.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |